Schluter DITRA HEAT Matting is polyethylene membrane with a cut-back stud structure and an anchoring fleece laminated on the underside. It is a universal substrate for tile coverings, which serves as an uncoupling, crack bridging, waterproofing, vapour pressure equalization layer and is designed to be used as a carrying membrane for the Schluter DITRA HEAT E HK Heating Cable.

Schluter DITRA HEAT Matting is available in either 12 metre rolls (12m length x 1m width), single 1m² units (multiple 1m² units will be supplied as a single roll) or single 0.8m² mats (0.8m x 1m).

This membrane is also available with a self-adhesive fleece backing for easier and faster installation – the Schluter DITRA HEAT PS Self Adhesive Matting.

Schluter DITRA HEAT Matting can be used on both walls and floors. The Schluter DITRA HEAT E HK Heating Cable snaps easily into place in the matting without the need for fasteners or clips. The heating cable can be installed wherever it is necessary in the matting, meaning you can put heating cables only under the areas that you want to heat – creating a cost efficient and effective under tile heating installation.

This matting is non-rotting, waterproof, elastic and crack-bridging. The material is highly resistant to solutions containing salts, acids and alkalis, as well as many organic solvents, alcohols and oils. The suitability of the material must be verified based on the specific chemical stresses, including the anticipated concentration, temperature and length of exposure. The water vapour diffusion seal of the material is relatively high. The material is physiologically safe. In special cases, the suitability of the material must be verified based on the anticipated chemical and mechanical stresses.

The adhesive and the covering materials used in conjunction with Schluter DITRA HEAT Matting must be suitable for the corresponding application and meet the applicable requirements. We recommend using a 6mm notch trowel when installing, such as the Schluter TROWEL.

Request Product Prices